Three cutting methods
1. straight cut
Use a ruler to draw a straight line on the board, the base of the machine is close to the board surface, and press and hold the cutting direction of the jigsaw by hand.
2. the curve cutting
If it is a curve with a small radius, buy a saw blade with a narrower width. Straight saw blades and jig saw blades are not the same. If the lower point is in the middle of the board, you need to drill a hole with the drill bit before you can lower the knife. Use 1 gear when cutting the curve.
3. bevel cutting
When using, loosen the screw connecting the base and the saw body, first move the base horizontally to the far right end, and then move the base longitudinally to the desired angle. Please reset the base after use. Attention: When using this function, the plastic cover for sawdust can not be put down, so the sawdust cleaning function can not be used. The sawdust cleaning function is only suitable for straight cuts, otherwise the saw blade may break.